Results 1 to 4 of 4

Thread: Bleeding Brakes Question

  1. 05-24-2007, 12:17 PM #1
    CharlieGTo6
    CharlieGTo6 is offline
    Warming Up
    Join Date
    May 2007
    Location
    Washington DC
    Age
    29
    Posts
    116

    Bleeding Brakes Question

    I just got done installing a TCI roll control. Now theres alot of air obviously, but do I just need to bleed them from the master cylinder block or from the calipers? I've seen a guy doing it from the cylinder, block.
    Reply With Quote Reply With Quote
  2. 05-24-2007, 04:00 PM #2
    dixonk
    dixonk is offline
    DEAD
    Join Date
    May 2007
    Posts
    6,869
    It will be a lot easier bleeding from the master cylinder. Since your not installing new brake lines at the calipers there should be no need to bleed from the calipers.
    Reply With Quote Reply With Quote
  3. 05-27-2007, 02:27 PM #3
    SSWs6
    SSWs6 is offline
    Warming Up
    Join Date
    May 2007
    Posts
    119
    really? how do you do it from the master cylinder
    Reply With Quote Reply With Quote
  4. 05-28-2007, 10:54 AM #4
    dixonk
    dixonk is offline
    DEAD
    Join Date
    May 2007
    Posts
    6,869
    Unscrew them a bit and pump the brakes. Then hold and tighten up again. Same as on the calipers.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

LSX Chevy Camaro & Corvette, Pontiac GTO & Firebird, & GM Trucks - LS1 Forum